TECH OT-MD BLACKOUT BUILD-OUT

Description

The TECH OT-MD BLACKOUT BUILD-OUT is a fully-customizable, all black compact open-top tool bag with an extra wide body. The TECH OT-MD BLACKOUT BUILD-OUT features our V-SWAP™ system, allowing for customization of the interior pocket layout by simply swapping panels for different storage layouts.   Customers MUST PURCHASE AT LEAST 2 V-Swap™ REMOVABLE AND EXCHANGEABLE Panels; this bag is NOT sold without panels. Panels may be added below.

This bag features a center storage space that houses a repositionable insert box with a magnetic lid that can be used as a parts tray.  Added depth increases the capacity and stability of this bag.

WHAT’S THE DIFFERENCE BETWEEN A BLACKOUT AND A BLACKOUT/BUILD-OUT BAG?

Two panels are automatically included with a Blackout bag. You do not choose them. For the Tech OT-MD Blackout, the 5X3 Pocket Panel and the 4X4 Pocket Panel are included with that bag.  The “Blackout Build-Out” version requires you to choose and purchase any two panels you want to start your bag with. Both allow you to purchase any additional panels for various configurations and maximum flexibility to handle any job.

Veto Pro Pac Tool Bags Product Care and Maintenance

Keep the Zippers Clean & Lubricated

Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.

Protect the Zippers From Sharp Objects and/or Excessive Heat

Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Don’t Overstuff the Bag

Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!

TECH OT-MD BLACKOUT BUILDOUT PRODUCT SHEET