The MB5B Tester Bag is designed for a Multifunction Tester (MFT) and is an extra large and highly-configurable front accessed meter bag. Once the bag is loaded out, it can be worn over both shoulders using the INCLUDED BACKPACK STRAPS, over a single shoulder using the optional padded shoulder strap (sold separately), as a sling bag using the Sling Strap (sold separately) or at your side with over-molded gripped handle. Finally, the bag features an additional 8 pockets on the front flap as well as a padded tablet computer pocket on the back. The MB5B is offered in two configurations: one for technicians in the United States and one for technicians in the UK, Europe and the rest of the international professional trade community. The MB5B Tester Bag, designed for technicians outside of the United States, has been optimized for safely storing a Multifunction Tester (MFT) inside the bag while also accommodating hand tools in any of the exterior pockets.  Each of the two padded, side mounted zippered meter pockets will securely fit meters up to 10”/26cm/260mm x 3.5”/9cm/ 90mm x 2”/50mm.

COMES WITH THE BAG: (and also available for additional purchase)

• Removable Backpack Straps
• V-Swap Large Side Pocket Inserts
• MFT Accessory Box
• V-Swap Front Padded Panel
• V-Swap Rear Padded Panel
• PB2-8 MAG Parts Bags

SOLD SEPARATELY (Does not come with bag)

• V-Swap Rear Bulk Storage Panel
• V-Swap Rear Tool Panel
• V-Swap Front Tool Panel
• Padded Shoulder Strap
• Sling Strap

VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE

Keep the Zippers Clean & Lubricated

Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.

Protect the Zippers From Sharp Objects and/or Excessive Heat

Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Don’t Overstuff the Bag

Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!

MB5B TESTER BAG PRODUCT SHEET