A string of magnets added long the back of this pair of 8″/20cm long parts bags adds a surprising amount of functionality. Not only do the magnets enable the pair to secure to one another, each magnetized pouch can attach to the ferrous mounting point integrated in the TP-XXL, TP-XD & TP-XL. When on the go the pouches can secure themselves to a substructure keeping small parts, test leads or precision tools within hand’s reach. The magnets can also temporarily keep the screws from a removed shroud in place.

VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE

Keep the Zippers Clean & Lubricated

Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.

Protect the Zippers From Sharp Objects and/or Excessive Heat

Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Don’t Overstuff the Bag

Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!

Download The Product Sheet of

PB2-8 MAG PRODUCT SHEET