The TECH-MC BLACKOUT BUILD-OUT is a fully-customizable, stealth version of our compact (2 inches shorter than the TECH-MCT), full-featured service, repair or installation tool bag that features everything you have come to expect from Veto Pro Pac: patented center panel, heavy duty construction and stabilizing injection molded waterproof base that keeps tools dry even in wet conditions. The TECH-MC BLACKOUT BUILD-OUT features our V-SWAP™ system, allowing for customization of the interior pocket layout by simply swapping panels for different storage layouts.   Customers MUST PURCHASE AT LEAST 2 V-Swap™ REMOVABLE AND EXCHANGEABLE Panels; this bag is NOT sold without panels. Panels may be added below.

With up to 38 pockets (depending upon panels inserted), two storage bays and 10.5” (27cm) of vertical interior storage space, this bag offers maximum storage for hand tools, meters and cordless drills in the MC platform. The TECH MC BLACKOUT BUILD-OUT includes D-rings, bit extension and memory stick pockets, and a stainless steel tape clip as well as a quick access outside pocket for drill bit extensions and small items. Featuring Veto Pro Pac’s proprietary V-SWAP™ system. Alternative tool pocket panels are available separately and can be swapped-out enabling tool, gear or job specific storage solutions. With the BUILD-OUT version, you choose which two panels to include with the purchase of the bag.

WHAT’S THE DIFFERENCE BETWEEN A BLACKOUT AND A BLACKOUT/BUILD-OUT BAG?

Tool and Meter panels are included when you purchase the “Blackout” version. The “Blackout Build-Out” version requires you to purchase any two panels you want. Both allow you to purchase any additional panels for various configurations and maximum flexibility to handle any job.

VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE

Keep the Zippers Clean & Lubricated

Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.

Protect the Zippers From Sharp Objects and/or Excessive Heat

Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Don’t Overstuff the Bag

Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!

TECH-MC BLACKOUT BUILDOUT SELL SHEET