Find A Dealer


Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)


Extra Large Open Top Contractor’s Tool Bag

- +
Add to Compare


With 2 horizontal ‘slick’ pockets & variety of exterior vertical tool pockets, the TF-XXL was designed from the ground-up for the art of timber framing. With a foot print of 9” X 25-1/2” the bag can easily accommodate a framing square, a 24” level & other hand tools often needed to assemble & erect a timber framed building.  Also, ideal as a BULK STORAGE TOOL BAG FOR ANY TRADE.




  • Height (BH): 14” (35.5cm)
  • Handle Height (HH): 20" (51cm)
  • Width (W): 26" (66cm)
  • Depth (D): 11" (28cm)
  • Weight (empty):  11 lbs/5 kg
  • Internal Volume: 2900in3/47L
  • Max Payload: 50lbs/23kg


  • 55 Vertically Tiered Pockets
  • Interior Removable Tool Pocket Panel
  • Padded Shoulder Strap
  • Exterior Mounted Stainless Steel Tape Clip
  • Waterproof Polypropylene Plastic Base
  • 5 Year Limited Warranty


  • Warranty: 5 Years (see Veto warranty terms and conditions)



Additional Information


Keep the Zippers Clean & Lubricated

Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.

Protect the Zippers From Sharp Objects and/or Excessive Heat

Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.

Don’t Overstuff the Bag

Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!

Download The Product Sheet of


There are no videos available for this product

Reviews (1)

1 review for TF-XXL

  1. Rated 5 out of 5

    jbc9801 (verified owner)

    I just purchased this bag and it is by far my favorite of the four Veto bags I own. I named this bag, “The Beast” because it is exactly that! While I am not a framer but rather an AV guy and this bag holds every tool I need including my 3 Milwaukee drill/ drivers with room to spare! I have been looking a long time for a bag that could hold every tool I need for whatever situation I faced and I have finally found it! Thanks Veto!

Add a review